Not to mention the people using their old fanatec pedals, with the aid of the basherboards Fanatec to Thrustmaster pedal adaptor. People have been using the T500RS pedal set for forza 5 since the TX was released (same connector), and some have also been using the T3PA pedal set clutch since they released to the general public. Make sure that the locking screw on the wheel stem is properly in place also, if it isnt, the wheel will become loose from the base unit.Īlso Owen, the clutch pedal worked with the older firmware. So that may mean the rim didn’t make a proper connection, or you didnt have the rim screwed on tight enough. There are plenty of people who are using the GTE rim, and doing so without the issue you are facing. That is stated in the manual somewhere, and I would suggest following that advice. While loading to a track in forza, DO NOT move the wheel, press any buttons on the wheel, press any of the pedals. Unplug the wheel from the xbox one, turn instant on mode off on your xbox one and turn it off (in the xbox settings menu, under power options), disconnect the power to the wheel, disconnect the pedals, take off the F458 rim, put the GTE rim back on, plug in the pedals, reconnect the power to the wheel, turn on your xbox one and wait for it to fully boot up, plug the usb cable for the wheel back into the xbox one, allow it to calibrate, sign into your profile, start up forza, check your desired rotation in the forza advanced controller settings, load up a car and a track, and test it out.Īlso, and this is very important.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |